Roksan radius turntables

Cut a hole in the bottom of the Radius motor housing base board for the new motor to fit through (I used a 50mm hole cutter to allow enough room for adjustments etc.).

Despite the fact that I did not buy direct from your company, I am absolutely delighted with what the kit has done for the deck. The stock motor was always way too loud for my liking, to the point where it became unbearable and your kit has now got me back to the standards I enjoyed with my Gyrodec. All I can say is thank you for your continuing to design solutions to problems that do exist rather than simply creating a 'product'
that doesn't already exist just for the sake of it, and also for your time in responding to my request. I will savour my next few months with my born-again deck before upgrading the power supply.