Fitting to Systemdek llX 900

1. Remove base board from t/table by unscrewing four rubber feet.

2. Unscrew motor connections from choccy block. Unscrew motor from mounting plate (obvious when u see it).

3. Remove motor and clip mains lead off transformer. Poke remains of mains lead through exit hole of deck.

4. Mount origin live dc motor from underneath using single screw into botom of top plinth.

5. Thread dc motor lead through old hole left by mains lead. Adjust motor position and fit belt.

Done in half an hour. Don't replace base board as no mains voltage now passes through deck.

Systemdek llX 900